Why is there water or oil leaking from the bottom of my Shark Pressure Washer pump?
A small amount of leaking from the bottom of the Shark Pressure Washer pump is normal. However, if excessive leaking occurs, contact technical support.
What to do if my Shark BR has low operating pressure?
If your Shark Pressure Washer has low operating pressure, it could be due to several reasons. The water supply might be insufficient, the faucet might be closed, or the inlet hose might be kinked. Try using a larger garden hose, cleaning the inlet water screen, and opening the faucet. It could also be due to a clogged inlet hose strainer (check plumbing system for leaks and retape leaks with Teflon tape), the machine has been stored in freezing temperatures (thaw out machine completely, including hose, spray gun and wand).
Why is there no detergent coming out of my Shark Pressure Washer?
If there's no detergent coming out of your Shark Pressure Washer, make sure the detergent suction tube is properly connected to the machine. If the detergent is too thick, dilute it. Ensure the detergent filter valve is not at the lowest setting; set it to a higher setting. Also, check if the filter on the detergent suction tube is clogged and run warm water through it to remove debris. If the detergent suction tube is damaged or clogged, remove the obstruction or replace the tube. Ensure that the black detergent nozzle is attached and that the discharge nozzle is not obstructed; blow it out or remove debris with a fine needle.
How to fix a leaking spray wand on my Shark BR Pressure Washer?
If the spray wand on your Shark Pressure Washer is leaking: * **Spray wand not properly attached:** Slide the spray wand into the gun and turn the wand collar clockwise onto the spray gun threads until tight.
Why is there water in the pump oil of my Shark Pressure Washer?
The presence of water in the pump oil of your Shark Pressure Washer can be due to: * Water sprayed at the machine. Change the oil and direct the spray away from the machine. * High humidity in the air. Check and change the oil twice as often. * Worn piston packing or oil seal. Contact technical support.
Why won't my Shark BR Pressure Washer engine start or why does it stop?
If your Shark Pressure Washer engine won't start or stops during operation, there are a few potential causes: * **Low oil shutdown:** Refill the engine with oil. * **Water in gasoline:** Drain the gas tank and replace it with clean fuel. * **Out of gas:** Simply fill the fuel tank.
Why does my Shark BR Pressure Washer engine lack power?
If your Shark Pressure Washer engine lacks power, it might be caused by a dirty air filter. Replace the air filter to resolve this issue.
What causes a Shark BR Pressure Washer to have low pressure after normal use?
Low pressure in your Shark Pressure Washer after a period of normal use can be attributed to: * A worn nozzle. Replace the nozzle. * A worn unloader valve. Replace the unloader valve.
Is it normal for my Shark Pressure Washer to leak water or oil from the bottom of the pump?
A small amount of leaking from the bottom of the pump on your Shark Pressure Washer is normal. If excessive leaking occurs, call technical support.
What to do if my Shark BR Pressure Washer engine lacks power?
If your Shark Pressure Washer engine lacks power, the air filter might be dirty (replace the air filter).
General| Series | BR Series |
|---|---|
| Power Source | Electric |
| Type | Electric |
| Hose Length | 20 feet |
| Power Cord Length | 35 feet |
| Nozzles Included | 0°, 25°, 40° |
To Next Page
