Shark Detect Pro IW1000 Series User Manual

55sharkclean.eu54 sharkclean.eu
AUTO-EMPTY ASSEMBLY (IW3000 SERIES) NON-AUTO-EMPTY ASSEMBLY (IW1000 SERIES)
1. Slide the Wand onto the neck of the Floor
Nozzle until it clicks into place.
2. Align the Hand Vacuum nozzle opening
with the top of the wand and slide it on
until it clicks into place.
3. Make sure the Dock is facing upright. Slide
the Charging Post into the slot on front of
dock until it clicks.
4. Place the dock on the floor near a wall
outlet. Plug the Power Cord into the outlet,
then connect the cord to the port on the
back of the charging post.
5. Store the crevice tool accessory on the
mount on the dock.
6. Refer to pages 56 and 57 for Odour
Installation and Replacement instructions.
For proper operation, ensure all components
are completely connected and clicked
into place.
1. Slide the Wand onto the neck of the Floor
Nozzle until it clicks into place.
2. Align the Hand Vacuum nozzle opening
with the top of the wand and slide it on
until it clicks into place.
For proper operation, ensure all components
are completely connected and clicked
into place.
Flex
Wand
Hand Vacuum
Storage Clip
Hand Vacuum
Storage Clip
Handheld
Vacuum
Handheld
Vacuum
Floor Nozzle Floor Nozzle
NOTE: Once the charging post is installed, it can’t be removed.
2.
(Click)
2.
(Click)
1.
(Click)
1.
(Click)
4. Power Cord
6.
Odour
Installation
3.
Assembled
Dock
5.
Accessory
Storage
ENGLISH

Shark Detect Pro IW1000 Series Specifications

General

Brand	Shark
Model	Detect Pro IW1000 Series
Category	Vacuum Cleaner
Language	English