UPRIGHT CLEANING
Your hard floors and carpets will thank you.
NOTE: DO NOT use to pick up drywall dust or fireplace ash.
1 Plug power cord into electrical outlet and press
POWER button to turn vacuum on.
2 For Hard Floor Cleaning
Set Floor Selector to Hard Floor and Suction Control
to Max for full suction or variable depending on user
preference.
For Thick Carpet & Area Rugs Cleaning
Set Floor Selector to Carpet and Suction Control to
Min for reduced suction or variable depending on
user preference.
For Carpet Cleaning
Set Floor Selector to Carpet and Suction Control to
Max for full suction or variable depending on user
preference.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in
carpets) please set to Carpet and Suction Control to Max
3 Place your left foot gently on the motorized floor
nozzle and tilt the handle back to start cleaning.
NOTE: The brushroll will only spin when the floor
selector is set to CARPET and the vacuum is reclined
back.
STEP 1 STEP 2 STEP 3
Suction Control
Floor Selector
MinMax
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
• Solid Green: The brushroll is on and working as it should.
• Solid Red: There is a jam in the brushroll area. Turn your vacuum off and remove the blockage.
• * Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum off and wait for it to cool down.
*See Troubleshooting section for further instructions.
To Next Page
Loading...
Need help?
General
