sharkclean.comsharkclean.com
NOTE: All accessories are compatible with both the wand and the handle.NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
WHOLE-HOME CLEANING
CLEANING MODES
To engage Brushroll, place foot on floor
nozzle and tilt handle back firmly.
Select surface setting:
O Power O
I Hard Floor
For bare floors and small area rugs.
II Carpet
For carpets.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn o and unplug the vacuum and remove any
blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn the vacuum o and wait a
minimum of 45 minutes for the unit to cool down.
Press the Wand Release button and pull up on
the wand to detach it from the pod.
Press the Handle Release button and pull up on
the handle to detach it from the wand.
Attach a cleaning accessory to handle or wand.
UPRIGHT MODE
POWER/SURFACE SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—WAND
ACCESSORIES—WAND
ABOVE-FLOOR—HANDLE
ACCESSORIES—HANDLE
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
The Suction Control Slider located on the top
of the handle allows you to adjust the suction
depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
SUCTION CONTROL
To Next Page
Loading...
Need help?
General
