sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, pull up on the dust cup
release button located on the top of dust cup
handle. Tilt dust cup forward, then lift to
remove.
To reinstall, place the bottom of dust cup
onto the pod and then tilt until it clicks into
place.
Press the release button to open bottom of
dust cup.
To remove collected debris from Lint Screen,
press the top release button and lift the
handle to open the dust cup. Gently brush
lint screen toclean.
RINSE HEPA FILTER
EVERY YEAR
Tilt Filter Door and firmly pull it o. Press
tab at top of HEPA Filter and pull out filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To rinse filters, use cold water only to prevent damage from cleaning chemicals. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electronicparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Post-Motor
HEPA Filter
Foam
Felt
Filter
Door
To Next Page
Loading...
Need help?
General
