Shark NV255 - Emptying the Dust Cup; Cleaning and Replacing Filters; Clean Pre-Motor Filters; Clean HEPA Filter

sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, press button on top of dust
cup handle. Tilt dust cup forward, then lift to
remove.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into place.
Press lower release button to open bottom of
dust cup.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
CLEAN HEPA FILTER
EVERY YEAR
Press down top of Filter Door. Tilt filter door
and lift out. Press tab at top of HEPA Filter
and pull away from the base of the vacuum.
To reinstall, insert HEPA filter into unit and
replace the filter door.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all
filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn
into electricparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Post-Motor
HEPA Filter
Foam
Felt
Filter
Door