7
www.sharkclean.com
2 Wait 30 seconds for the boiler to
heat the water. Pump the handle
a few times to prime the pump,
activate steam and moisten the
micro-fiber pad. (fig. 4)
3 Mop with a forward and backward
motion to customize steam output
automatically. (fig. 5)
IMPORTANT: Never leave the Light &
Easy™ Steam Mop with a damp/wet
micro-fiber pad on any floor surface
for any amount of time as this may
damage the floor.
If your Light & Easy
™
Steam
Mop stops steaming, it could
be out of water. Unplug the
power cord from the electrical
outlet and refill the water tank
at anytime.
fig. 4
fig. 5
To Next Page
Loading...
Need help?
General
