Sharp 5P-27G - Connection to Other Audio Systems; External Audio System Connections; Tape Erasing Procedure

Push the record key and play key ( ® Play)
simultaneously.
v v
Review ad
eialsaen
sew. Gua)
Awiew
eRecord +4 Rewind ley Stop sElect 6 Posane
=
mmm
Upon completion of recording, push the
Stop/Eject key to stop tape running.
(It is, however, noted that when the tape
has reached its end, the key is reset to auto-
matically stop the tape even without depres-
sion of the Stop/Eject key.)
= Erasing Recorded Tape
In this tape recorder, the pre-recorded content is automatically erased
when recording anew. However, when you desire to erase the recorded
content without recording, take the following procedures.
1. Install cassette tape and set the TV/Radio/Sleep/Tape Selector (Mode)
“lort|”
Tape
. Insert erasing plug into the microphone jack (MIC).
to position.
. Turn the mixing balance control fully to ““Mic” side.
. Push the record key and play key simultaneously.
oo FP W KN
. Upon completion of erasing, push the Stop/Eject key.
Recording through DIN Microphone
® Connect DIN microphone with the DIN socket (a_0). (The built-in
microphone is, in turn, powered off automatically and only the DIN
microphone can operate.)
® During recording through the built-in microphone or DIN microphone,
Monitoring of the recorded content is impossible, however.
a
14
11 Connection to Other Audio Systems
fe Nn i ee
= Perform connection between this receiver and other external apparatus as
follows. (Please purchase connection cord separately.)
- o
Radio
LL
Stereo set
- Comm Oo
° oon
0
Stereo amplifier or Deck
v
Mike °) som
(for
Mixing
a
Telephone
T= pick-up
(G3
Telephone
When connection cords with
resistance are used, perform
connection following the
dotted lines.
@® Miniplug > Miniplug Note:
@ DIN plug > DIN plug