Sharp 5P-27G - Recording Methods; Temporary Tape Control

lf an earphone (furnished) or headphone (not furnised) is connected (Remote). When the remote control switch is turned off, tape is stop-
respectively to earphone jack or headphone jack, record monitoring is also ped temporarily.
possible through earphone or headphone. At this time no sound comes out Note: @ Even when tape is in a temporary stop, power is kept still alive.
of the speaker, however. Therefore, after the operation, never fail to push the Stop/
=
Recording
through
Wireless
Microphone
Eject
Key
and
set
the
TV/Radio/Sleep/Tape
selector
(Mode)
to “’ Off «. position to turn off power.
: Tape
Make the.tadio. be ready.to operate.and turn e@ Since ALC (Automatic Record Level Control) circuit is in-
the tuning control (Radio) to tune with
transmitting frequency of wireless mike.
corporated in this set, there is no bother of manually adjusting
the record level during operation.
Recording through Built-in Mike or DIN Mike
Set
the
Mode
Selector
(Mode)
to
“
Off
,,
Tape
[2] Carry out recording in the same procedure as that of ‘‘Recording”’
from TV or Radio”’.
= Temporary Tape Stop
During recording or playback, tape can be stopped temporarily for various
purposes such as editing records or writing down contents recorded on the
tape.
position.
Push the Stop/Eject key to open cassette
holder.
Review ~~ Cue———_] ue
@Record << Rewind me tf » Play sStop 4Eject Pause
1. Temporary stop by the pause key
If the pause key is pushed once during recording or play back, tape
stops temporarily. When the key is pushed again, temporary stop is
released and tape restarts.
Set cassette tape.
2. Temporary stop through the remote control
Insert remote contro! plug of either the remote control switch or the
remote-controlied external microphone into the remote control jack
13