AH-X127E
AU-X127E
AY-X127E
AE-X127E
43
13. Cut the band.
14. Disconnect five wires from the control box to the reactor
and capacitors.
(To reactor: two wires / To capacitor: three wires)
16. Remove two screws which are fixing heat insulator
assembly. And take it out.
17. Remove two screws which are fixing bulkhead. And take
it out.(Fixing the bottom part is used special screw)
15. Take out the control box and put it just under.
(The compressor cord is still wired)
18. Disconnect the compressor cord.(Three wires)
To Next Page
Loading...
