WASHING THE FRONT PANEL
Be sure to detach the front panel from the indoor unit before washing.
Dry thoroughly before attaching it.
Front Panel
n
1
2
3
Turn off the unit and detach the front panel.
Raise the front panel up until it stops.
l
Push the left and right supports of the
front panel gently to the out side
accordingly, and unhook them.
Wash with water.
Wash gently with water and soft sponge.
Dry it thoroughly in the shade. (Do not
use scouring pads, as it will damage the
front panel surface.)
Mild detergent may be used when the
front panel is very dirty. Rinse thoroughly
with water.
Attach the front panel back in place.
Hold each support with each hand.
Carefully push in the supports until the
hooks fit the inside holes.
CLEANING THE UNIT AND THE REMOTE CONTROL
l
Wipe them with a soft cloth.
l Do not directly splash or pour water on them. It could result in electrical shock or
damage to them.
l
Do not use hot water, thinner, abrasive powders or strong solvents.
POST-SEASON CHECK
r
PRE-SEASON CHECK
1
2
3
Operate the unit in the FAN ONLY
mode for about half a day to allow
the mechanism to thoroughly dry.
Stop the operation and unplug the
unit. Turn off the circuit breaker, if
you have one exclusively for the
air conditioner.
Clean the filters, then reinstall
them.
1
2
3
Make sure that the air filters are
not dirty.
Make sure that nothing obstructs
the air inlet or outlet.
Check the outdoor mounting rack
periodically for wear and to make
sure it is firmly in place.
To Next Page
