l
l
Be sure that your headphones have a 3.5 mm
(l/8”)
diameter
plug and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for desired
volume.
H
VIDEO/AUX
(Audio signal) input
To listen to or record signals from external sources
through this unit:
1
l
2
3
4
5
Use an RCA lead to connect the desired external unit to the
VIDEO/AUX
sockets.
(red
+
right channel, white
+
left channel)
When using video equipment (Laser Disc player, VCR), be
sure to connect the audio output to this unit and the video
output to a television.
Set the ON/STAND-BY switch to ON.
Press the
VIDEO/AUX
button.
Operate the external unit.
To record the sound from the external unit, perform steps 2
-
4 of the “Recording from the built-in radio” section on page
13.
Note:
0
To prevent hum interference, do not place this unit near tele-
vision receivers.
15
9
2
34
9
F.’
I
\JI
Before you move this product to a new location, proceed as
follows:
1
2
3
l
4
0
5
Set the ON/STAND-BY switch to ON.
Press the CD button.
Press the OPEN/CLOSE button to open the disc tray.
Remove all CDs inserted in the unit.
Press the OPEN/CLOSE button to close the disc tray.
Make sure that “NO DISC” is displayed.
Set the ON/STAND-BY switch to STAND-BY, and then unplug
the AC power lead from the AC socket.
To Next Page
Loading...