Sharp AH-PN10 - Using the Remote; Auxiliary Mode; Tips on Saving

ENG-
E-5
AUX
7 m
18,000/24,000 BTU
AUX
LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries.
(AAA(R03))
Make sure the (
+
) and (
-
) polarities are
correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1 year in
normal use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
USING THE REMOTE CONTROL
Battery cover
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the receiver
window and press the desired button. The
unit generates a beep when it receives the
signal.
• Make sure nothing, such as curtains, block the
signal receiver window.
• The signal effective distance is 7 m.
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely affect its operation.
• Use of certain fluorescent lamp in the same room
may interfere with transmission of the signal.
• Do not leave the remote control in direct
sunlight or near a heater. Protect the remote
control from moisture and shock.
Use this mode when the remote control is
not available.
TO TURN ON
Press the AUX button.
• The red OPERATION lamp ( ) will light and
the unit will start operating in the AUTO mode.
• The fan speed and temperature setting are
set to AUTO.
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp ( ) will turn off.
AUXILIARY MODE
TIPS ON SAVING ENERGY
Below are some simple ways to save energy
when you use your air conditioner.
Set the proper temperature
• Setting the temperature lower than neces-
sary during cooling operation will result in
increased power consumption.
Block direct sunlight and prevent drafts
•
Blocking direct sunlight during cooling operation
will reduce power consumption.
• Close the windows and doors during cooling
operation.
Keep filter clean to ensure the most efficient
operation
Disconnect the power cord or turn off the
circuit breaker when the unit is not used for an
extended period of time
• The indoor unit still consumes a small amount
of power when it is not operating.
Receiver window
RESET button
9,000/12,000 BTU
OM_AH-PN10 13GY_EN.indd Sec1:5OM_AH-PN10 13GY_EN.indd Sec1:5 12/22/11 6:30:14 PM12/22/11 6:30:14 PM