E-6
2
3
1
4
1
Press the MODE button to select the
operation mode.
2
Press the ON/OFF button to start
operation.
• The red OPERATION lamp ( ) will light up.
TO TURN OFF
Press the ON/OFF button again.
• The red OPERATION lamp ( ) will turn off.
3
Press the THERMOSTAT button to
set the desired temperature.
(AUTO/DRY mode)
The temperature can
be changed up to ±2 °C
the automatically set of
temperature.
(COOL mode)
The temperature setting
range:
16-30°C.
4
Press the FAN button to set the
desired fan speed.
BASIC OPERATION
AUTO COOL DRY
AUTO SOFT LOW HIGH
NOTE:
AUTO MODE
In the AUTO mode, the temperature setting and mode are automatically selected according to the
room temperature when the unit is turned on.
DRY MODE
The fan speed is preset to AUTO and cannot be changed.
WHEN POWER FAILURE OCCURS
This air conditioner has a memory function to store settings when a power failure occurs.
After power recovery, the unit will automatically re-start in the same settings which were active before
the power failure, except for timer settings.
OM_AH-PN10 13GY_EN.indd Sec1:6OM_AH-PN10 13GY_EN.indd Sec1:6 12/22/11 6:30:16 PM12/22/11 6:30:16 PM
To Next Page
Loading...
