Sharp AH-XP Series - DISPLAY BUTTON; MAINTENANCE; CLEANING THE FILTERS; CLEANING THE UNIT AND THE REMOTE CONTROL

EN-13
Be sure to disconnect the power cord
from the wall outlet or turn off the
circuit breaker before performing any
maintenance.
CLEANING THE FILTERS
1
Turn off the unit.
2
Remove the lters.
①
Lift the open panel.
②
Pull the air lters down to re-
move them.
3
Clean the lters.
• Use a vacuum cleaner to remove
dust. If the lters are dirty, wash
them with warm water and a mild
detergent. Dry lters in the shade
before reinstalling.
4
Reinstall the lters and close
the open panel.
CLEANING THE UNIT AND THE RE-
MOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour wa-
ter on them. It can cause electrical
shock or equipment damage.
• Do not use hot water, thinner, abra-
sive powders or strong solvents.
Press the DISPLAY button when the
lamps on the unit are too bright.
1
During operation, press the
DISPLAY button.
• The lamps on the unit will become
dark.
TO LIGHT UP
Press the DISPLAY button again.
1
DISPLAY BUTTON MAINTENANCE
“OM TINSEB052JBRZ EN+CS+TH”文件夹.indb 13 2018/10/19 15:27:28