EN-5
HOW TO USE THE REMOTE CONTROL
Point the remote control towards
the receiver window and press the
desired button. The unit generates
a beep when it receives the signal.
• Make sure nothing, such as curtains,
block the signal receiver window.
• The signal effective distance is 7 m.
CAUTION:
• Do not expose the receiver window
to direct sunlight. This may adversely
affect its operation.
• Use of certain uorescent lamp in
the same room may interfere with
transmission of the signal.
• Do not leave the remote control
in direct sunlight or near a heater.
Protect the remote control from
moisture and shock.
LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries.
(AAA(R03))
Make sure the (+) and (-) polarities
are correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1
year in normal use.
• Replace the batteries when the re-
mote control displays " ".
• When replacing the batteries, always
change both and use the same type.
• If you will not be using the unit for a
long time, remove the batteries from
the remote control.
Battery cover
RESET button
7 m
Receiver
window
USING THE REMOTE CONTROL
“OM TINSEB052JBRZ EN+CS+TH”文件夹.indb 5 2018/10/19 15:27:21
To Next Page
Loading...
Need help?
General
