CONVENIENT COPY FUNCTIONS
32
Using the RSPF
1
Place the original(s) in the RSPF. (p.25)
If you place an odd number of originals for one-sided to two-sided copying,
the last page will be one-sided.
2
Press the [2-SIDED COPY] key and select
the two-sided copy mode that you wish to
use.
The mode changes as follows each time you press
the [2-SIDED COPY] key:
"1 TO 1" → "1 TO 2" → "2 TO 2" → "2 TO 1"
• "1 TO 2": Two-sided copies from one-sided originals
• "2 TO 2": Two-sided copies from two-sided originals
• "2 TO 1": One-sided copies from two-sided originals
3
Press the [ENTER] key.
If you selected "1 TO 2" in step 2, select "LONG EDGE" or "SHORT EDGE"
and press the [ENTER] key. LONG EDGE and SHORT EDGE are shown in
the illustration on page 30.
4
If you selected "2 TO 1" or "2 TO 2", press
the [ ] key ( ) or [ ] key ( ) to select
the original size and then press the
[ENTER] key.
The following original sizes can be selected:
"8.5x14", "8.5x13", "8.5x11", "5.5x8.5", "A4", "B5",
"A5"
5
Select the number of copies and any other settings, and then
press the [START] key ( ).
The copy will be delivered to the paper output tray.
To cancel automatic two-sided copying, press the [CLEAR ALL] key
( ) or press the [2-SIDED COPY] key, select the "1 TO 1", and then
press the [ENTER] key.
Note
!AL-2050CS.book 32 ページ ２００８年１月７日 月曜日 午後８時１０分
To Next Page
Loading...
