EasyManua.ls Logo

Sharp Aquos LC-19SB280UT

Sharp Aquos LC-19SB280UT
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preparation
Using
the
remote
control unit
Use the remote control unit by pointing it towards the remote control sensor on
the TV. Objects between the remote control unit and the remote control sensor
may prevent proper operation.
Cautions'
regarding
rel1lot,~
control unit
Do not expose the remote control unit to shock.
In
addition,
do
not expose the remote control unit to liquids, and do not place in an area
with high humidity.
Do not install or place the remote control unit under direct sunlight. The heat may cause
deformation of the remote control unit.
The remote control unit may not work properly if the remote control sensor on the
TV
is
under direct sunlight or strong lighting.
In
such cases, change the angle of the lighting or
the TV, or operate the remote control unit closer to the remote control sensor.
Antennas
To
enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of
connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with
an
F-type connector, plug it into the antenna terminal at the rear of the TV set.
1.
A 75-ohm system is generally a round cable with F-type
connector that can easily be attached to a terminal
without tools (Commercially available).
F-type connector
+
----~1OCt}
75-ohm coaxial cable (round)
2. A 300-ohm system is a flat ''twin-lead'' cable that can be
attached to a 75-ohm terminal through a 300/75-ohm
adapter (Commercially available).
300-ohm twin-lead
cable
(flat)
_ F-type connector should be
fingertightened only.
When connecting the RF cable to the
TV
set, do not tighten
F-type connector with tools.
If tools are used, it may cause damage to your TV set. (The
breaking of internal circuit, etc.)
~~
~Ftypeconnector
75-ohm coaxial cable
Connecting Antenna Cable
Home
Antenna
CD
Cable without a Cable TV lead-In terminal (75-ohm)
CATV converter
~
c:a~\==<CJ
Coaxial cable
(commercially available)
@ VHF/UHF antenna
Connect
the
antenna cable
to
the
TV
using
one
of
the
methods
in
the
illustration
as
shown
(CD,
@, @
or
@).
or 75-ohm coaxial cable (round)
300-ohm twin-lead cable (flat)
~~~~==r:===.
To
TV
antenna terminal
300175-ohm
adapter
(commercially available)
300-ohm
twin-lead cable
'. \ Combiner
300-ohm twin-lead
cable\DerciallY
available)
.
--~~,
...............
~IID~
or
75-ohm coaxial cable /
~
do
VHF UHF
ANTENNA ANTENNA
Home Antenna
75-ohm coaxial cable (round) terminal (75-ohm)
'--
~
c:a~\==<CJ
Coaxial cable
(commercially available)
@ Combination
VHF/
UHF
antenna
@ Separate VHFI
UHF
antenna
@-12

Table of Contents

Related product manuals