Sharp Aquos LC-19SB280UT

Connecting to External Equipment
• When using DVI-HDMI conversion cable (INPUT 3):
Rear of the TV
f',
r~[E01HJIPm'3 .
II I.!" fj1 ~DVI-HD, "M,' conversion cable
'I "~ t.iII~
II i
'
lXI9Xiiiill 'lIlI~
" !)
o 3.5 mm stereo minijack cable
Bmm
• When using an OVI-HOMI conversion cable, you should make an analog audio connection. In this case, in addition to connecting an OVI-
HOMI conversion cable to the INPUT 3 (HOM I) terminal, connect an audio cable to the AUOIO PC/HOMI terminal and set "HOMI Audio" to
"OVl". (See page 26.)
• When using analog RGB cable (INPUT 4):
Analog RGB cable
(D-sub 15pin cable
/~=::-::-" or VGA cable)
~
@D.I@J D
,1i!I
--=111 III=-
o 3.5 mm stereo minijack cable
Bmm
• When using an analog RGB cable, input the audio signal to the AUOIO PC/HOMI terminal of INPUT 4.
Di$playing an image 'fr,C?rn I) ~C
To view an image from a PC, perform the following procedure.
<D Select the Input 4 (PC) mode using INPUT on the remote control or the TV set. (See page 13.)
® Adjust the "Picture" items if the PC image does not come in clearly. (See page 26.)
",. """"<
PC cqmp~tibility chart .'~'
c"':':"':"" ':"":'-:'<:';',.,0,"",- '-,<;i<",V>.)., _:/,:"'" "'.' ,c', ":'::"':'.,',:-,:''''','''_ .... J,.'., ..... "-
720 x 400 31.5 kHz 70Hz
VGA
31.5 kHz 60Hz
0
640 x 480 37.9 kHz 72 Hz 0
37.5 kHz 75 Hz 0
35.1 kHz 56 Hz 0
SVGA
37.9 kHz 60Hz 0
PC
800 x 600
48.1 kHz
72Hz
0
46.9 kHz
75Hz
0
48.4 kHz 60Hz 0
XGA 1,024 x 768 56.5 kHz 70 Hz 0
60.0 kHz 75 Hz 0
WXGA
1,280 x 768
47.8 kHz
60Hz 0
@-17
1,360x768 47.7 kHz 60Hz 0