Sharp Aquos LC-37D33X - Supplying Electric Power to the Antenna; Initial Auto Installation

Preparation
Press POWER on the TV.
• The initial auto installation wizard appears.
1
Setting the on-screen display language.
2
Press
a
/
b
to select the desired language,
and then press ENTER.
3
Initial auto installation
When the TV powers on for the fi rst time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Confi rm the following before turning on the
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
English
Digital Search
Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto Installation” in “Setup” section
(refer chapter “Watching TV” on manual).
Press ENTER.
4
The TV searches for, sorts and stores all
the receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress,
press END.
5
NOTE
• If you turn off the power on the TV after performing step 4,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the Setup menu. (Page 20)
• The initial auto installation wizard will go off if you leave
the TV unattended for 30 minutes before searching for
channels in step 5.
Supplying electric power to the
antenna
When you set-up the DTV antenna for the fi rst time,
or connect the antenna to a community antenna, you
need to proceed to set the antenna by following this
manual.
Selected item Description
On Select “On” when your antenna is set-up
and connected independently.
Off Select “Off” when you do not need to
supply voltage to your antenna, i.e.
when your antenna is connected to a
community antenna. (The factory default
setting of this function is “Off”.)
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Setup”.
2
Press
a
/
b
to select “Antenna Setup-
DIGITAL” and then press ENTER.
3
Press
a
/
b
to select “Supply Voltage” and
then press ENTER.
4
Press
c
/
d
to select “On” and then press
ENTER.
5
• Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto Installation” in “Setup” section (See
page 20).
11
32D33X_en_b.indd 1132D33X_en_b.indd 11 2008-1-24 14:52:312008-1-24 14:52:31