43
Watching TV
ATV (Analogue)/DTV/RADIO buttons
Use the following buttons on the remote control to
operate the menu.
ATV: Press to switch to analogue mode. After
switching from DTV, radio or external input mode to
analogue mode, the TV jumps to the most recently
viewed analogue channel.
DTV: Press to switch to DTV mode. After switching
from analogue, radio or external input mode to DTV
mode, the TV jumps to the most recently viewed DTV
channel.
RADIO: Press to switch to radio mode. After switching
from DTV to radio mode, the TV jumps to the most
recently tuned radio channel.
When you watch the TV for the fi rst time
When the TV powers on for the fi rst time after
purchase, perform the auto installation.
ATV (Analogue TV)
You can run the auto installation to set channels
automatically.
To watch the analogue TV, select “Auto
Installation” from Setup menu. (See page 20.)
1
DTV
When the TV accesses to DTV mode for the fi rst time,
you need to run the auto search. To scan all available
services in your area, follow the procedures below.
After setting the channels, you can select
a channel using CH
r
/
s
or 0—9 on the
remote control unit. (See page 21.)
2
To watch DTV broadcasts, select “Digital
Search” from auto installation menu. (See page
11.)
1
After setting the channels, you can select
a channel using CH
r
/
s
or 0—9 on the
remote control unit. (See page 21.)
2
32D33X_en_f.indd 4332D33X_en_f.indd 43 2008-1-24 15:58:062008-1-24 15:58:06
To Next Page
Loading...
