Sharp AQUOS LC-40LE814E

17
Quick guide
Checking signal strength and
channel strength (DVB-T/C/S/S2)
IfyouinstallaDVB-T/C/S/S2antennaforthefirsttime
orrelocateit,youshouldadjustthealignmentofthe
antennatoreceiveagoodreceptionwhilecheckingthe
antennasetupscreen.
1 Go to “Menu” > “Setup” > “View setting”
> “Channel settings” > “Antenna setup-
DIGITAL”.
2 Press a/b to select “Digital setup” or
“Satellite setup”, and then press ;.
E Checking signal strength
3 Press a/b to select “Signal strength”, and
then press ;.
Signal strength for DVB-T/C
Supply voltage
CH No.
Current Max.
Signal strength
Signal strength
Channel strength
Current Max.
Quality
Signal strength for DVB-S/S2
Current Max.
Signal strength
Signal strength
Channel strength
Current Max.
Quality
E Checking channel strength
4 Press a/b to select “Channel strength”, and
then press ;.
• Youcaninputaspecifiedfrequencybandusingthe0_9
numericbuttons.
Channel strength of DVB-T
Supply voltage
CH No.
Current Max.
Signal strength
MHz
Signal strength
Frequency
Channel strength
Current Max.
Quality
Channel strength of DVB-C
Supply voltage
Current
Max.
Signal strength
MHz
Signal strength
Frequency
Symbol rate
QAM modulation
Channel strength
Current Max.
Quality
Channel strength of DVB-S/S2
Current Max.
Signal strength
MHz
Signal strength
Frequency
Symbol rate
Band
Channel strength
Current Max.
Quality
Vert/Low
5 Position and align the antenna so that
the maximum possible values for “Signal
strength” and “Quality” are obtained.
NOTE
• Thevaluesof“Signalstrength”and“Quality”indicatewhento
checktheappropriatealignmentoftheantenna.
Supplying power to the antenna
Youmustsupplypowertotheantennainordertoreceivedigitally/terrestriallybroadcaststationsorsatellite
broadcaststationsafterconnectingtheantennacabletotheantennaterminalontherearoftheTV.
1 Press@andthe“Menu”screendisplays.
2 Pressc/dtoselect“Setup”,andthenpress;.
3 Pressc/dtoselect“Viewsetting”,andthenpress;.
4 Pressa/btoselect“Channelsettings”,andthenpress;.
5 Pressa/btoselect“Antennasetup-DIGITAL”,andthenpress;.
6 Pressa/btoselect“Supplyvoltage”,andthenpress;.
7 Pressc/dtoselect“On”,andthenpress;.