Sharp AQUOS LC-40LE814E - Watching TV; Daily operation

16
2 When you change the antenna
connection setting:
Press c/d to select “Change setting” on the
DVB-S/S2 setting screen in the left column,
and then press ;.
• Theantennaconnectionsettingscreenisdisplayed.
Single satellite
2 satellites on 22kHz switchbox
2 satellites on toneburst switchbox
Max. 4 satellites on DiSEqC multiswitch
Communal satellite system
NOTE
• Youcanselecttheantennaconnectionmethodfromthefive
types.Consultyourdealersbeforeusingamethodotherthan
“Singlesatellite”.
E “Single satellite” setting
1 Press a/b to select “Single satellite”, and
then press ;.
2 Press a/b to select “SAT1 [None]” to display
the satellite broadcasts that the TV can
receive, and then press ;.
SAT1 [None]
Next
3 Press a/b/c/d to select your favorite
satellite, and then press ;.
• Youcannotselect“Next”unlessyousetthesatellite
broadcastinstep3.
Euro Bird 1
Atlantic Bird 1
4 Press a/b to select “Next”, and then press
;.
SAT1 [ASTRA 1]
Next
5 Press c/d to select “Yes (0/22kHz)” or “No”
to set the LNB frequency, and then press ;.
Yes (0/22kHz)
No
6 Press a/b to select the item and press c/d
to adjust 9,000 MHz to 12,000 MHz to the
appropriate value.
EXAMPLE
SAT1 low
SAT1 high
OK
7 Press a/b to select “OK”, and then press
;.
After completing this setting, the screen
switches to the DVB-S/S2 setting screen
shown in the left column on page 15.
NOTE
• Followtheinstructionsonthescreenfor“2satelliteson22kHz
switchbox”,“2satellitesontoneburstswitchbox”,“Max.4
satellitesonDiSEqCmultiswitch”and“Communalsatellite
system”settings.
• Tosetmultiplesatellitechannels,goto“Max.4satelliteson
DiSEqCmultiswitch”.
Quick guide