Appendix
Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
• Before performing
work
make sure to turn off the
TV.
• Before performing
work
spread cushioning over the base area
to
lay the TV on. This will prevent it from being
damaged.
1
----
Hex key
----
2
Unfasten the four screws used to secure the stand
in
place.
Detach the stand from the
TV.
(Hold the stand so
it
will not drop from the edge
of
the base area.)
• To attach the stand, perform the above steps
in
reverse order.
• This TV should be mounted
on
the wall only with the AN-52AG4 (SHARP) wall mount bracket. The use of other wall
mount brackets may result
in
an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results
in
accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualified service professional about using
an
optional AN-52AG4 bracket to mount the
TV
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging
on
the wall
AN-52AG4 wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angle
Angular mountingVertical mounting
• Detach the cable clamp on the rear of the TV when using the optional mount bracket.
• To use this TV mounted on a wall, first remove the adhesive tape at the 4 locations on the rear of the
TV,
and then use the
screws supplied with the wall mount bracket
to
secure the bracket
to
the rear of the
TV.
@-
58
Appendix
Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
• Before performing
work
make sure to turn off the
TV.
• Before performing
work
spread cushioning over the base area
to
lay the TV on. This will prevent it from being
damaged.
1
----
Hex key
----
2
Unfasten the four screws used to secure the stand
in
place.
Detach the stand from the
TV.
(Hold the stand so
it
will not drop from the edge
of
the base area.)
• To attach the stand, perform the above steps
in
reverse order.
• This TV should be mounted
on
the wall only with the AN-52AG4 (SHARP) wall mount bracket. The use of other wall
mount brackets may result
in
an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results
in
accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualified service professional about using
an
optional AN-52AG4 bracket to mount the
TV
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging
on
the wall
AN-52AG4 wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angle
Angular mountingVertical mounting
• Detach the cable clamp on the rear of the TV when using the optional mount bracket.
• To use this TV mounted on a wall, first remove the adhesive tape at the 4 locations on the rear of the
TV,
and then use the
screws supplied with the wall mount bracket
to
secure the bracket
to
the rear of the
TV.
@-
58
To Next Page
Loading...
