8
On-screen Language
Selection
1
Press MENU (unless you have already selected
when the set was fi rst switched on). Then press
c
/
d
to select “OPTION”, then press
b
or
ENTER.
OSD Language
West
16:9
On
English
TT Language
Aspect Ratio
Blue Screen
Key Lock Off
OPTION
First Time Installation
Reset
Software Update(USB)
DivX Reg. Code
Deactivation
2
Press
a
/
b
to select “OSD Language”, then
press
c
/
d
to select the desired language.
3
Press RETURN to exit the menu.
Channel Setup
Press MENU. Select “CHANNEL/ATV Manual Tuning”,
then press
d
or ENTER.
Press
a
/
b
to select desired item, then press
c
/
d
to setting.
ATV Manual Tuning
Current CH 3
+
Color System NTSC
Sound System M
Fine-Tune 67.25 MHz
AFC On
Search
Menu
MENU
Current CH: Set the channel number.
Color System: Select the color system. Color System
has already been preset to automatic. Do not change
anything here. Any changes can cause picture or
sound disruption.
Sound System: Select the sound system. The correct
sound system is already installed. Any changes can
cause sound disruption.
Fine-Tune: Adjust the frequency of the channel fi nely.
AFC: Automatic Fine Tuning.
Search: Press
c
to search down from the current
frequency, and press
d
to search up.
Press RETURN to exit the menu.
Programme Edit
You can preset your favorite channel (Channel List).
Press MENU. Select “CHANNEL/Programme Edit”,
then press
d
or ENTER.
Programme Edit
ATV
ATV
ATV
ATV
ATV
ATV
ATV
ATV
ATV
ATV
2
1ABC
3
4
5
6
7
8
9
10
Delete
Rename Move Skip
Enter
ENTER
Menu
MENU
Delete (red button): You can delete channel.
Rename (green button): You can input or change the
name of a channel on the cursor screen with
a
/
b
/
c
/
d
, ENTER and Green buttons.
Move (yellow button): Press
a
/
b
to select the
position that you want to swap the channel with, then
press Yellow button.
Skip (blue button):
mark will appear.
Basic Operation
Channel selection
With the Numbered buttons (0-9).
Example:
• No. 2: Press 2.
• No. 29: Press 2 and within 2 seconds, press 9.
• No. 199: Press 1, 9, 9 same as above.
Press P +/- to change up or down a channel. This
takes approx. 2 seconds. If the auto search only stored
5 stations, only these 5 will appear. Skipped channels
will not appear.
NOTE
• As TV CH is called up when you input and set the fi rst digit,
CH inputs of over two digits cannot be made with external
input.
Channel List
The Channel List shows a list of all receivable
programmes.
Press CH LIST to display the Channel List.
Press
a
/
b
then press ENTER to select the desired
channel.
Press CH LIST to display the selected channel.
NOTE
• To display the programmes on the channel list, it is
necessary to input the programme name in “Programme
Edit” mode.
J3QQ1401C_EN.indd 8J3QQ1401C_EN.indd 8 5/27/2013 2:03:23 PM5/27/2013 2:03:23 PM
To Next Page
Loading...
