>>
<<
On-Screen Display Menu
ENG 4-23
Example
Smart TV (Continue)
Remote Control Link
Initial Setup
1 Switch the channel selection of your set-top box to any channel (except CH10).
2 Connect one end of the USB extension cable to the USB port of the TV.
3 Plug the IR blaster dongle to other end of the USB extension cable. Then place the dongle near the IR receiver of your set-top
box.
4 Press MENU and select Smart TV > Remote Control Link. The SmartCentral Remote Control Link Setup screen appears.
5 Press
/ to select "Yes" and press ENTER to continue.
To Next Page
Loading...
