Sharp Aquos LC-65UB30U

>>
<<
Using LINK Operation
ENG 6-1
Controlling HDMI Equipment Using LINK Operation
What’s LINK Operation?
Using the HDMI CEC (Consumer Electronics Control) protocol, with LINK Operation you can
interactively operate compatible system equipment (Blu-ray disc equipment, AV amplifier,
DVD).
To access this function: Initial Setup > Advanced > AQUOS LINK Setup > AQUOS LINK
Control.
NOTE
For connecting the TV to LINK-compatible equipment, use commercially available cables.
Point the remote control toward the TV, not to connected HDMI equipment.
Video noise may occur depending on the type of HDMI cable used. Make sure to use an
HDMI-certified cable.
Up to 4 pieces of HDMI recording equipment and one AV amplifier can be connected using
this system.
These operations affect the HDMI equipment selected as the current input source. If the
equipment does not operate, turn on the equipment and select the appropriate input source
using INPUT.
The LINK feature may not operate properly when an HDMI splitter or AV selector unit is used.
These devices may cause interruptions to the image and/or sound.
Connected
LINK-compatible devices can be operated without changing the settings of the
remote
control unit.
Control the LINK-compatible audio system
Set
the volume of LINK-compatible audio system.
NOTE
The steps in "AQUOS LINK Setup" on page 6-2 need to be completed beforehand.
Refer to this operation manual and the operation manual of the LINK device to be used with
this TV.