23
MAKING COPIES
B/W REVERSE
The B/W REVERSE feature is used to reverse black and white areas.
●
When the B/W REVERSE feature is selected, the exposure mode will be
automatically set to the MANUAL mode. Other exposure modes cannot
be selected.
Even if this feature is cancelled, the MANUAL mode will not
automatically be cancelled.
1
Place the original on the original table and close the
platen cover.
2
Press the B/W REVERSE key.
3
Check the copy paper size.
●
If an optional paper feed unit is installed:
Use the ORIGINAL SIZE ENTER key to select the original size.
Copy paper of the same size as the original will be automatically
selected. If desired, another paper tray can be selected by pressing the
TRAY SELECT key.
4
Make all other desired copier selections and press the
START key.
B/W reverse
Original Copy
To Next Page
Loading...
