17
MAKING COPIES
Two-sided copies from two-sided originals
1
Ensure that no original is left on the original table. Adjust
the original guides to the size of the originals and set the
originals face up in the document feeder tray.
●
5-1/2" x 8-1/2" size original or copy paper cannot be used.
2
Use the ORIGINAL TO COPY key to select .
●
When this mode is selected, the RSPF indicator will light up even if no
original has been set in the document feeder tray.
3
Set the number of copies and press the START key.
●
Be sure not to touch the originals as they move on the reversing tray.
This may cause misfeeds.
Normal copying
NORMAL COPYING
3
Set the number of copies and press the START key.
●
To stop a copy run during duplex copying, press the CLEAR ( )
key.
To cancel the duplex mode, press the ORIGINAL TO
COPY key repeatedly until the indicators in the
ORIGINAL TO COPY section all go out.
To Next Page
Loading...
