Why is the scanner transfer speed slow on my Sharp Copier?
If the scanner transfer speed on your Sharp Copier is slow, it may be because your computer does not meet the system requirements for the USB 2.0 interface (Hi-Speed mode). See 'System requirements for USB 2.0 (Hi-Speed mode)' in the Operation Manual to configure your system as required for USB 2.0, and then set 'USB2.0 MODE SWITCH' in the user programs to 'HI-SPEED'.
Why my Sharp All in One Printer does not operate?
If the Sharp All in One Printer is not operating, ensure it is plugged into a grounded outlet and the power switch is turned on. If the power save indicator is blinking, the machine is warming up. Also, check that the front or side cover is completely closed. If the machine is in auto power shut-off mode, press the start key to resume normal operation. Finally, ensure that the scan head locking switch is unlocked.
Why Sharp AR-M150 copies are smudged?
If your Sharp All in One Printer copies are smudged or dirty, it could be due to a dirty document glass or the underside of the SPF/RSPF, so clean them regularly. Alternatively, the original document might be smudged or blotchy, so try using a clean original.
How to fix paper misfeed in Sharp AR-M150?
If you're experiencing a paper misfeed with your Sharp All in One Printer, there are several potential causes. Consult the "MISFEED REMOVAL" section for instructions. Ensure you are using copy paper within the specified size and weight range and that the paper is not curled or damp. Make sure the paper is loaded properly, and remove any pieces of misfed paper. Avoid overloading the tray and fan the paper before loading it. Ensure the guides on the bypass tray match the paper width and that the bypass tray extension is pulled out. Finally, remove any excess paper from the output tray.
Why Sharp AR-M150 shows tray location indicator?
If the tray location indicator is on, it means the indicated paper tray is either not attached, attached incorrectly, or has run out of paper. Add paper or ensure the tray is correctly attached.
How to adjust the exposure on Sharp All in One Printer for better copy quality?
If your Sharp All in One Printer produces copies that are too dark or too light, ensure you select the correct original type using the exposure settings. You can select AUTO with the [EXPOSURE] key, or manually adjust the exposure using the [] or [] keys. You may also adjust the automatic exposure level.
General| Functions | Print, Copy, Scan, Fax |
|---|---|
| Print Speed | 15 ppm |
| Print Resolution | 600 x 600 dpi |
| Copy Speed | 15 cpm |
| Copy Resolution | 600 x 600 dpi |
| Scan Resolution | 600 x 600 dpi |
| Fax Modem Speed | 33.6 kbps |
| Max Paper Size | A3 |
| Paper Capacity | 250 sheets |
| Connectivity | USB 2.0 |
| Warm-up Time | 30 seconds |
| Original Size | A3 |
| Supported Operating Systems | Windows, Mac |
To Next Page
