AR-M207 M165 M162 EXTERNAL VIEWS AND INTERNAL STRUCTURES 4-2
2. Internal
Warning: The fusing unit is hot. Do not touch the fusing unit when removing misfed paper. Doing so may cause a burn or injury.
Caution: Do not touch the photoconductive drum (green portion) when removing the misfed paper. Doing so may damage the drum and cause
smudges on copies.
Note: The model name is on the front cover of the machine.
21 Toner cartridge lock release lever To replace the toner cartridge, pull out the toner cartridge while pushing on this lever.
22 Toner cartridge Contains toner.
23 Document feeder tray (when the SPF is installed) Place the original(s) that you wish to scan face up here. Up to 40 sheets can be
placed.
24 Original guides (when the SPF is installed) Adjust to the size of the originals.
25 Feeding roller cover (when the SPF is installed) Open to remove misfed originals.
26 Right side cover (when the SPF is installed) Open to remove misfed originals.
27 Fusing unit release levers To remove the paper misfed in the fusing unit, push down on these levers and
remove the paper.
28 Roller rotating knob Rotate to remove misfed paper.
29 Exit area (when the SPF is installed) Originals exit the machine here after copying/scanning when the SPF is used.
30 Reversing tray (when the RSPF is installed) Pull out to remove misfed originals.
31 Photoconductive drum Images are formed on the photoconductive drum.
32 Fusing unit paper guide Open to remove misfed paper.
2728
22
21
23 24
25
26
31 32
29 30
[04]EXTERNALVIEWS.fm 2 ページ ２００４年１１月１２日 金曜日 午後２時８分
To Next Page
Loading...
