AR-M207 M165 M162 SIMULATIONS 7-17
24 05 Duplex print counter clear
Used to clear the duplex print counter.
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
06 Paper feed counter clear
Used to clear the paper feed counter data in each paper feed section.
* TRAY2-TRAY4 are displayed only when they are installed.
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
07 Drum counter clear
Used to clear the drum counter and the drum rotating time.
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
08 Copy counter clear
Used to clear the copy counter.
[OK] or [START] key: Clears the copy counter and shifts to the sub code input window.
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
09 Printer counter clear
Used to clear the printer counter and other counters.
Select a counter to be cleared and press [OK] key or [START] key. The confirmation window is displayed.
Press [OK] key or [START] key again, and the specified counter is cleared and the machine returns to the
initial window.
[CA] key: Exits the simulation mode.
[Interruption] key: Shifts to the sub code input window.
Main
code
Sub
code
Contents Remark
Sim24-5 COUNTER CLR
AER YOU SURE? EXEC
DUPLEX
COUNTER
CLEAR
Sim24-6 COUNTER CLR Sim24-6 COUNTER CLR Sim24-6 COUNTER CLR
10 Key
1:BYPASS
2:TRAY1
3:TRAY2
4:TRAY3
5:TRAY4
0
1:BYPASS
2:TRAY1
3:TRAY2
4:TRAY3
5:TRAY4
2
1:BYPASS
2:TRAY1
3:TRAY2
ARE YOU SURE?
4:TRAY3
5:TRAY4
2
C Key
OK/START
OK/START
Return
(Initial window (Counter selection window) (Confirmation window)
Sim24-7 COUNTER CLR
AER YOU SURE? EXEC
DRUM
COUNTER
CLEAR
Sim24-8 COUNTER CLR
AER YOU SURE? EXEC
COPIES
COUNTER
CLEAR
Sim24-9 COUNTER CLR Sim24-9 COUNTER CLR
1:PRINT
2:OTHER
OK/START
OK/START(Counter clear)
Return
10-key input
1
1:PRINT
2:OTHER
1ARE YOU SURE?
[07]SIMULATIONS.fm 17 ページ ２００４年１１月１７日 水曜日 午後１２時１１分
To Next Page
Loading...
