AR-M205 USER PROGRAMS 8-2
*2 On models with a dual function board.
*3 On models with automatic two-sided copying.
Program name
Program
No
Description Default Parameters
Layout in 2 IN 1 copy*
2
17
Use this setting to select the layout pattern when two original pages
are copied onto a single sheet of paper.
Pattern 1
1 (Pattern 1)
2 (Pattern 2)
Layout in 4 IN 1 copy*
2
18
Use this setting to select the layout pattern when four original pages
are copied onto a single sheet of paper.
Pattern 1
1 (Pattern 1)
2 (Pattern 2)
3 (Pattern 3)
4 (Pattern 4)
Offset of paper output tray
19
When enabled, this function offsets the position in the output tray of
interrupt copy jobs and sets of copies during sort/group copy.
ON
0 (OFF)
1 (ON)
Image rotation in duplex
copying*
3
20
When a one-sided portrait original is placed in a horizontal
orientation (8-1/2" x 11" or 8-1/2" x 14" size) for two-sided copying,
the top and bottom of the images on the front and back of the paper
will be opposite to each other,
OFF
0 (OFF)
1 (ON)
Location of the margin*
2,
*
3
21
Use this setting to switch between the margin at the top edge and
the margin at the left edge.
Left edge
1 (Left edge)
2 (Top edge)
Margin width*
2
22
Use this setting to set the margin width.
1/2" (10mm)
1 (0" (0mm))
2 (1/4" (5mm))
3 (1/2" (10mm))
4 (3/4" (15mm))
5 (1" (20mm))
Resolution in Auto/Text
mode 23
The copy resolution in auto and text mode is normally 300 dpi.
If high-quality copies are preferred, use this setting to change the
resolution to 600 dpi.
300dpi
1 (300dpi)
2 (600dpi)
Memory allocated to
printer mode*
2
24
Use this to change the proportion of IMC memory used for printer
mode.
50%
1 (30%)
2 (40%)
3 (50%)
4 (60%)
5 (70%)
Key auto repeat
25
Use this setting to select whether or not holding down a key causes
repeated input of the key. For keys that normally cause a set value to
increase when held down (for example, holding down the [ZOOM]
key ( , )), this program can be used to have the set value not
change when the key is held down.
ON
0 (OFF)
1 (ON)
Key press time
26
Use this setting to select how long a key must be pressed for the
input to be accepted. By selecting a longer time, you can prevent
settings from being changed by the accidental pressing of a key.
Minimum
(current
response
speed)
1 (Minimum
(current response speed))
2 (0.5sec)
3 (1.0sec)
4 (1.5sec)
5 (2.0sec)
Audible signals volume
27
This sets the volume of beep signals.
Low
(current
volume)
1 (Low (current volume))
2 (High)
3 (OFF)
Base setting beep signal
28
Use this to sound a beep when a base setting is selected.
OFF
0 (OFF)
1 (ON)
Number of copies limit
29
Use this setting to select 99 or 999 for the maximum number of
copies.
999 copies
1 (99 copies)
2 (999 copies)
2 IN 1 copy
Pattern 2
Pattern 1
4 IN 1 copy
Pattern 1 Pattern 2 Pattern 3 Pattern 4
% !"#$
To Next Page
Loading...
