SCANNING SETTINGS (ORIGINAL SIZE, EXPOSURE, RESOLUTION, AND FILE FORMAT)
22
6
Enter the X (width) and Y (length) dimensions
of the original with the keys.
X (width) is initially
selected.
Enter X and then touch
the ( ) key to enter Y.
A width of 64 to 432 mm
(2-1/2" to 17") can be
entered in X, and a
length of 64 to 297 mm (2-1/2" to 11-5/8") can be
entered in Y.
7
Touch the outer [OK] key.
The original size entered in step 6 is stored in the
key selected in step 5.
To exit, touch the [ORIGINAL] key.
8
When you touch a key that shows an
original size in step 5, a message screen
appears that contains the keys [CANCEL],
[DELETE], and [AMEND].
To cancel the procedure, touch the [CANCEL]
key.
To delete the selected original size, touch the
[DELETE] key.
To change the original size stored in the key,
touch the [AMEND] key. The screen of step 6
will appear to let you change the size.
9
To exit, touch the [ORIGINAL] key.
Using a stored original size
1
Follow steps 1 to 3 of "STORING OR
DELETING AN ORIGINAL SIZE".
2
Touch the original size key that you wish
to use.
3
Touch the [OK] key.
The stored original size is called up.
ENLARGEMENT TRANSMISSION
If the original size for scanning is not a long size or a non-standard size, you can enlarge a transmission by specifying
the size that is to be sent.
1
Touch the [ORIGINAL] key.
2
Touch the [SEND SIZE] key.
The sizes that can be
selected as the send
size are displayed.
*If a B/W scanner
module/SPF is installed,
the [2-SIDED] keys are
not displayed.
3
Touch the desired send size key.
If you wish to select an
inch size, touch the
[INCH] key and then
touch the desired send
size key.
4
Touch the [OK] key.
The specified size is
displayed as the send
size.
5
Touch the [OK] key.
You will return to the
initial screen.
To Next Page
Loading...
