SPECIAL FUNCTIONS
30
3
Enter the X dimension (width) and Y
dimension (length) of the original with the
keys.
OX (width) is initially selected. Enter X and then
touch the Y ( ) key to enter Y.
OTo return the X and Y values to the initial
settings configured in the key operator
programs, touch the [SIZE RESET] key. (key
operator's guide "CARD SHOT SETTINGS"
on page 15)
OTo have the image enlarged or reduced by a
suitable ratio based on the entered original
size and the send size so that the front and
back sides fit into the transmitted paper size ,
touch the [FIT TO SEND SIZE] key.
OTo cancel the card shot function, touch the
[CANCEL] key.
4
Touch the outer [OK] key.
You will return to the
screen of step 1 and a
card shot icon will
appear next to the
[EXPOSURE] key.
5
Place the original on the document glass.
Place the front side of
the original face down
and close the document
cover.
6
Follow steps 4 through 22 of "BASIC
TRANSMISSION METHOD" (pages 12
to
14).
7
Press the [START] key.
The front side of the card
is scanned.
8
Place the back side of the original face
down on the document glass. (see step 5)
9
Press the [START] key.
The back side of the
card is scanned.
10
Touch the [READ-END] key.
A beep will sound to inform you that the
transmission was stored.
To Next Page
Loading...
