Sharp AR-M450 - Page 75

AR-M350 SIMULATIONS 10-14
* CIS is displayed only when DSPF is installed.
<List of set values>
*1 Displayed when OPTION of multi-purpose only.
*2 Displayed when manual feed OPTION is added.
5-3
Purpose Operation test, check
Function (Content) Used to check the operations of the copy lamp
and its control circuit.
Section Scanner (reading), DSPF (reading)
Item Operation
Operation/Procedure The copy lamp or CIS is lighted for 10sec and
turned off.
SIMULATION 5-3
COPY LAMP TEST. SELECT 1-2, AND PRESS START.
1.COPY LAMP
2.CIS
1
SIMULATION 5-3
COPY LAMP TEST. EXECUTING...
1.COPY LAMP
2.CIS
1
Press [START] key to get started.
Press [CUSTOM SETTING] key to stop.
Stops after 10sec.
Main code 6
6-1
Purpose Operation test, check
Function (Content) Used to check the operation under load
(clutches and solenoids) in the paper transport
system and their control circuits.
Section Paper transport (paper exit, switchback,
transport)
Item Operation
Operation/Procedure Select with 10 digit key pad.
2 HLPR (Heater power relay)
3 DCPR (DC power relay)
4 MM (Main motor)
5 DM (Drum motor)
6 DSB_FW (Stepping motor forward rotation)
7 DSB_RV (Stepping motor reverse rotation)
8 CPFC (Paper feed clutch)
9 RRC (Resist roller clutch)
10 TRC (Transport roller clutch)
11 FGS_FIN (Finisher gate solenoid)
12 LUM (Tray 1 lift-up motor)
13 TRC_DSK (Desk clutch sync signal)
14 PSPS (Separation pawl solenoid)
15*1 MCM(MP drive motor control signal)
16*1 MCPCL(MP tray paper feed clutch signal)
17*1 MCFCL(MP tray transport clutch signal)
18*1 MCLUM(MP tray lift-up motor signal)
19*2 MPFS (Manual paper feed solenoid signal)
20*2 MPFC (Manual paper feed clutch signal)
21*2 MSS (Manual paper feed gate solenoid)
SIMULATION 6-1
FEED OUTPUT CHECK. SELECT 1-17, AND PRESS START.
 2.HLPR 3.DCPR 4.MM 5.DM 6.DSB_FW
7.DSB_RV 8.CPFC 9.RRC 10.TRC 11.FGS_FIN
12.LUM 13.TRC_DSK 14.PSPS
15.MCM 16.MCPCL 17.MCFCL 18.MCLUM
19.MPFS 20.MPFC 21.MSS
2
SIMULATION 6-1
FEED OUTPUT CHECK. EXECUTING...
 2.HLPR 3.DCPR 4.MM 5. DM 6.DSB_FW
7.DSB_RV 8.CPFC 9.RRC 10.TRC 11. FGS_FIN
12.LUM 13.TRC_DSK 14.PSPS
15.MCM 16.MCPCL 17.MCFCL 18.MCLUM
19.MPFS 20.MPFC 21.MSS
2
Press [START] key to get started.
Press [CUSTOM SETTING] key to stop.
Or stops after repeating
the specified number of times.
 (       !"# $%&