E – 6
IMPORTANT INSTRUCTIONS
To the water tank with room temperature water
suitable for drinking is a must for
SuperSteam Convection and Steam in both
Automatic and Manual Cooking. Be sure to follow
the directions below.
1. Pull the water tank toward you to remove.
2. Wash the water tank and lid for the first time.
(Figure 1)
3. Fill the water tank withroom temperature water
suitable for drinking through the lid to
the 2 mark (MAX mark) each time you begin to
cook. (Figure 2) Do not fill the water tank over the 2
mark (MAX mark).
4. Make sure the lid is closed firmly.
5. Install the water tank by pushing firmly. (Figure 3)
6. After cooking, empty the water tank and wash the
water tank and the lid.
NOTES:
1. Do not use any other liquids like distilled water, R.O
water, mineral water and etc.
2. An insufficient amount of water in the water tank
may cause an undesired result.
3. We recommend that you empty the water tank every
time after cooking. Do not leave the water tank filled
with water in the oven over a day.
4. If any messages, such as “Fill water tank” ,areas
shown in the display during cooking, refer to
Troubleshooting Chart on page E-26.
5. Do not drop or damage the water tank. Heat may
cause the water tank to change shape. Do not use
a damaged water tank.
Contact a SERVICE
CENTRE APPROVED BY SHARP.
6. There may be a few water drops when removing
the water tan
k. Wipe the oven dry with a soft cloth.
7. Do not block the air holes on the lid of the water
tank. It will cause trouble during cooking.
8.
A small amount of water will drain into the drip tray
when the water tank is removed. Empty after cooking.
Be su r e t o c o o k w i t h d r i p t r a y i n po si t i o n an d f o l l o w
the directions below .
The drip tray and the lid are packed with the oven. Place
the drip tray and lid under the oven door as shown in
Figure 4. This drip tray collects the condensation from
the oven door.
To remove
the drip tray: Pull the drip tray toward you
with both hands.
* Make sure water is not dripping down before removing
the drip tray.
To replace the drip tray: Place the drip tray onto the right
andlefthooksundertheovenandpushfirmlyasshownin
Figure 4. Insert the drip tray horizontally when you attach
it. Improper use may cause the damage to the hooks.
If “ Replace drip tray” or “ Empty drip tray and
replace” is asshown in the display, remove and then
replace the drip tray correctly.
Empty the drip tray after each time you cook. Empty,
rinse thoroughly, dry and replace. Failure to empty may
cause the drip tray to overflow. Cooking repeatedly
without emptying the drip tray may cause it to overflow.
WARNINGS :
1. The oven will become very hot after cooking and draining water function.
2. Do not open the oven with your face close to the oven. Steam from the oven may cause burns.
3.
Make sure that the oven has cooled before emptying the water tank and the drip tray and then wipe the oven cavity.
4. Do not touch the water directly as water in the drip tray may be hot.
3erugiF2erugiF
Figure 1
Figure 4
Read Carefully Before Cooking in SuperSteam Convection & Steam
Drip tray lid
Drip tray
Hooks
OM_AX1600_V1_1.indd 20 /02/ 2013 11:56PM
WATER TANK
DRIP TRAY
To Next Page
Loading...
Need help?
General