MAINTENANCE
Be sure to disconnect the power cord from the wall
outlet or turn off the circuit breaker before performing
any maintenance.
CLEANING THE FILTERS
1
Turn off the unit.
2
Remove the filters.
1
Lift the open panel.
2
Push the air filters up slightly to unlock them.
3
Pull the air filters down to remove them.
3
Clean the filters.
Use a vacuum cleaner to remove dust. If the filters
are dirty, wash them with warm water and a mild de-
tergent. Dry filters in the shade before reinstalling.
4
Reinstall the filters.
1
Reinstall the filters in the original positions.
2
Close the open panel.
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It can
cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders or
strong solvents.
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1
Operate the unit in the COOL mode, tempera-
ture setting 32˚C, for about half a day to allow
the mechanism to thoroughly dry.
2
Stop the operation and unplug the unit. Turn
off the circuit breaker, if you have one exclu
-
sively for the air conditioner.
3
Clean the filters, then reinstall them.
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
1
Make sure that the air filters are not dirty.
2
Make sure that nothing obstructs the air inlet
or outlet.
TIPS ON SAVING ENERGY
Below are some simple ways to save energy when
you use your air conditioner.
SET THE CORRECT TEMPERATURE
• Setting the thermostat 1°C higher than the desired
temperature in the COOL mode and 2°C lower in the
HEAT mode will save approximately 10 percent in
power consumption.
• Setting the temperature lower than necessary dur
-
ing cooling operation will result in increased power
consumption.
BLOCK DIRECT SUNLIGHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling operation will
reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
SET PROPER AIR FLOW DIRECTION TO OBTAIN
THE BEST AIR CIRCULATION
KEEP FILTER CLEAN TO ENSURE THE
MOST EFFICIENT OPERATION
MAKE MOST OF THE TIMER OFF FUNCTION
DISCONNECT THE POWER CORD WHEN
THE UNIT IS NOT USED FOR AN EXTENDED
PERIOD OF TIME
• The indoor unit still consumes a small amount of
power when it is not operating.
To Next Page
Loading...
Need help?
General
