Sharp CD-E700H - Memorising a station

02/12/6 CD-E700H(H)E2.fm
E-16
ENGLISH
8
CD-E700H
Radio
! Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or if the AC lead is discon-
nected.
! To recall a memorised station
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
This can be operated by pressing the TUNER PRESET ( or )
button on the remote control.
! To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
! To erase entire preset memory
1
Perform steps 1 - 3 in "Tuning" on page 15.
2
Press the MEMORY/SET button to enter the preset tuning
saving mode.
3
Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY/SET button to store
that station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
"
The preset number will flash and the programmed stations will
be tuned in sequentially, for 5 seconds each.
"
This can be operated by pressing the TUNER PRESET ( or
) button on the remote control.
2 Press the PRESET ( or ) button again when the desired sta-
tion is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the TUNER (BAND) button and the X-
BASS/DEMO button, press the ON/STAND-BY button until
"TUNER CL" appears.