02/12/6 CD-E700H(H)E2.fm
E-19
ENGLISH
CD-E700H
Tape Recording
Recording to a cassette tape (continued)
Notes:
"
When the end of the tape is reached whilst recording, the CD
player will display the track number which was being played at
that time, and stop automatically. If you want to restart recording
from the beginning of the interrupted track, turn over the tape,
press the REC PAUSE (TAPE-2 ) button and then the /
button. (If tracks have been stored in memory by programming,
recording will restart from the first track stored in memory.)
"
Whilst recording, OPEN/CLOSE button is deactivated. It is rec-
ommended to perform CD recording after closing the disc tray.
! Recording from the radio
To interrupt recording:
Press the REC PAUSE (TAPE-2 ) button.
To resume recording, press the / button.
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
! Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
! Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1
Tune in to the desired station. (See page 15.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
4
Press the / button to start recording.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
5
Press the / button to start dubbing.
1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Press the REC PAUSE (TAPE-2 ) button.
4 Press the / button to start erasing.
To Next Page
Loading...
Need help?
General
