E-18
ENGLISH
8
CD-ES111H
03/10/29 CD-ES111H(H)E.fm
TINSZA004SJZZ
Tape Recording
Recording to a cassette tape
Before recording:
z
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
z
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
z
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
z
For recording, use only normal tapes. Do not use metal or
CrO tapes.
z
Recording can be operated in the TAPE 2 compartment only. The
TAPE 1 compartment is for playback only.
Recording from a CD (CDs)
You can record 3 CDs continuously.
Erase-prevention tab of cassette tapes:
z
When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
z
To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the CD button and load the desired disc.
4 Press one of the 1 - 3 buttons on the remote control to
select the disc to be recorded first.
5 Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
6 Press the / button to start recording.
z
CD playback will start approximately 5 seconds after the
tape starts.
z
Recording is started from the selected CD. When the play-
back of the last disc is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
Side A
Tab for
side B
Tab for
side A
To Next Page
Loading...
