Sharp CD-M4000 - Video CD Playback; Video CD

TEST M,ODE
CD-M4000W/CP-M4000
l Setting the test mode
Any one of test mode can be set by pressing several keys as follows.
<X-BASS> + <CD> + <POWER> TEST:CD operation test
Function:-CD test mode.
-Enter test mode.
’
IL isn’t done
OPEN/CLOSE operation is using manual.
c~~77, ccc+> buttons’ make pick’s slide possible.
<<PLAY>> key input.
Do TOC IL. Do normal play
When these following key is input
into PLAY key, track number can
<<MEMORY>>
key input
be appoint directly
Adjustment result
automatically will
display as below
for each 2 set :
a) “FOF-XXXX”
b) “TOF-XXXX”
c) “TBA-XXXX”
d) “TGA-XXXX”
f) “FGA-XxXx”
g) “RFL-XXXX”
<<@ 177 key: Track 4
<<@2>7 key: Track 9
<<@3>> key: Track 15
explanation:
a) Focus off set
=“FOF XXXX”
I
b) Tracking off set
=“TOF;XXXX”
c) Tracking balance =“TBA-XXXX”
d) Tracking Gain
=“TGA-XXXX”
f) Focus Gain
=“FGA-XXXX”
g) RF level shift
=“RFL-XXXX”
VOL - Last memory
BAL - CENTER
P.GEQ - FLAT
X-BASS - OFF
To cancel : Power OFF
I
+
Laser ON.
<<MEMORY>> key input.
Tracking OFF play at that
specific point.
6
<<MEMORY>> key input.
<<MEMORY>> key input.
I
t
1 Adjustment result automaticallywill
display as below for each 2 set :
a) “FOF-XxXx”
b) “TOF-XXXX”
c) “TBA-XXXX”
d) “TGA-XxXx”
f) “FGA-XXXX”
g) “RFL-XXXX”
3
/ <<STOP: key input. /
(STOP)
Sliding the PICKUP with
<<DD>>, <cc+> button
must only be in STOP mode.
-15-