CD-M4000W/CP-M4000
NOTES
ON
SCHEMATIC
DIAGRAM
l
Resistor:
To differentiate the units of resistors, such symbol as
K
and
M
are used: the symbol
K
means 1000 ohm and the symbol
M
means 1000 kohm and the resistor without any symbol is
ohm-type resistor. Besides, the one with “Fusible” is a fuse
type.
. Capacitor:
To indicate the unit of capacitor, a symbol
P
is used: this
symbol
P
means pica-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic
capacitor, the expression “capacitance/withstand voltage”
is used.
(CH), (TH),
(RH),
(UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
l
Schematic diagram and Wiring Side of
P.W.Board
for this
model are subject to change for improvement without prior
notice.
9
The indicated voltage in each section is the one measured
by Digital Multimeter between such a section and the chas-
sis with no signal given.
1. In the tuner section,
indicates AM
indicates FM stereo
2. In the main section, a tape is being played back.
3. In the deck section, a tape is being played back.
(
)
indicates the record state.
4. In the power section, a tape is being played back.
5. In the CD section, the CD is stopped.
l
Parts marked with
“A
”
(
iI=
=
17
)
are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
SW734
TUNER
ON--m
SW801
VOLTAGE SELECTOR
230-240
V
EC
B
(9
(G)
WV
(1)
(2)
(3)
KTAI 266 GR KTC3203
Y
KTA1273
Y
KRC102
M
KTAI 274 Y
KRC104
M
KTC3194 Y
KRCI
07
M
KTC3199 GR 2SA1015 GR
2SC1845
F
TYPES
OFTRANSISTOR
AND
LED
BCE
(1)
(2)
(3)
KTC2026
KIA7810 AP
KIA7805 AP
FRONT
VIEW
I
I
4204s
RT7
4204UYT7
4204UGT7
31
URT21
-
39
-
To Next Page
Loading...
