E-25
ENGLISH
CD-MPX880H
Tape Playback
Listening to a cassette tape
(TAPE 1 or TAPE 2) (continued)
Various tape functions
Caution:
To remove the cassette, press the (TAPE ) button, and then
open the compartment.
Before changing from one tape operation to another, press the
(TAPE ) button.
If a power failure occurs during tape operation, the tape head will
remain engaged with the tape and the cassette door will not open.
In this case, wait until the power is restored.
Recording on a cassette tape
Function Main unit Remote
control
Operation
Playback Press in the stop
mode.
Stop Press in the
playback, fast
forward or rewind
mode.
Fast
forward/
Rewind
Press in the
playback or stop
mode.
(TAPE 2
only)
PRESETPRESET
Before recording:
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
The volume and sound controls can be adjusted with no effect
on the recorded signal (Variable Sound Monitor).
For recording, use only normal tapes. Do not use metal or
CrO tapes.
Erase-prevention tab of cassette tapes:
When recording on a cassette tape, make sure that the
erase-prevention tabs are not removed. Cassettes have
removable tabs that prevent accidental recording or erasing.
To protect the recorded sound, remove the tab after recording.
Cover the tab hole with adhesive tape to record on the tape
without the tab.
Tab for side B
Tab for side A
Side A
To Next Page
Loading...
Need help?
General
