E-38
ENGLISH
8
CD-MPX880H
Advanced Features
Enhancing your system
The connection lead is not included. Purchase a commercially
available lead as shown below.
Listening to playback sounds of portable audio
player, etc.
Note:
To prevent noise interference, place the unit away from the television.
Auto power on function:
When you press any of the following buttons, the unit turns on.
AUDIO IN button (main unit and remote control): The unit turns on
and the “AUDIO IN” function is activated.
/ button on the main unit: The unit turns on and playback of
the last function starts (CD,TAPE,TUNER,AUDIO IN).
To record sounds of portable audio player, etc.
Headphones
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
1 Connect a portable audio player, etc. to the front AUDIO IN
socket.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUDIO IN button.
4 Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
If volume level is too low, increase the volume of the connected
device.
TIMER
CD
4
3
1
5
4
5
3
2
1
PHONES
RECORD/PLAYBACK
PLAYBACK (PLAY & STOP)
2
Portable audio
player, etc.
Audio cable
(not supplied)
To the line output socket
1 Insert a cassette in the TAPE 2 cassette compartment.
2 Press the AUDIO IN button.
3 Press the button.
4 Press the / (TAPE ) button.
5 Play the portable audio player, etc.
TIMER
CD
4
3
1
5
4
5
3
2
1
PHONES
RECORD/PLAYBACK
PLAYBACK (PLAY & STOP)
2
AUDIO
IN
To Next Page
Loading...
Need help?
General
