Sharp CD-SW200 - Tape Playback; Listening to a Cassette Tape (TAPE 1 or TAPE 2)

03/12/19 CD-SW200 26- 33.fm
30
CD-SW200
Tape Playback
Listening to a cassette tape (TAPE 1 or TAPE 2)
 Tape playback
Auto power on function:
When you press any of the following buttons, the unit turns on.
 TAPE button (main unit and remote control): The unit turns on and
the "TAPE" function is activated.
 TAPE button on the remote control: The unit turns on and play-
back starts (regardless of the last function).
 / button on the main unit: The unit turns on and playback of
the last function starts (CD,TAPE,TUNER,GAME/VIDEO).
Auto power off function:
In the stop mode of tape operation, the main unit enters the stand-by
mode after 15 minutes of inactivity.
Before playback:
 For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not rec-
ommended.)
 Do not use C-120 tapes or poor-quality tapes, as
they may cause malfunctions.
 Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
CD-SW200
1
Press the ON/STAND-BY button to turn the power on.
2
Open the cassette com-
partment by pushing the
area marked " ".
3
Load a cassette into the
TAPE 1 compartment or
TAPE 2 compartment with
the side to be played fac-
ing toward you.
4
Press the TAPE (1 2) button to select the cassette you
want to listen to.
5
Press the / button to
start playback.
Tape play indicator
TAPE 1 TAPE 2