Sharp CE-150 - Page 15

A ll and more abo ut Sharp PC-1500 at http://www.PC-1500.info
Reassembly Parts S.ymbol
Sequence
12
Parts to be Reassembled Precautions for Rea ssembly
The wire must be stretched in the
order described below :
I) As shown in Fig. I , the spring
must be pressed against the side
plate using
a ftnger tip with the
knot of the wire in alignment
with the side plate at point (A) .
2) Next , thread the leading edge of
the wire through the puUey (B)
and the protrus ion (C).
3) As shown in Fig. 2. align the
slit (D) of the bobbin gear so
that ii should on a line drawn
between the bobbin ge ar shaft
(E) and th e idler gear shaft (F) .
® @
Fi g. 2
4) Wind th e wire arou nd the
bobbin gear for one and half a
tum , the n th r ead ii through
slits.
Fig.
3
Do not sale this PDF !!!