Sharp DV-SL10 - SETTING UP YOUR DVD PLAYER; Connecting a TV or a stereo TV that has component video in jacks

–
9
–
EN
SETTING UP YOUR DVD PLAYER
CAUTION:
• Be sure to turn off the Player and equipment to be connected before connecting.
• Read through the operation manual for the equipment to be connected.
• Be sure that the colours of the jacks and plugs match up when using a VIDEO/AUDIO cable.
• Be sure to keep the Player connection cables separate from the TV antenna cable when you install the Player, because it
may cause electrical interference when you are watching television programmes.
• DTS audio cannot be produced with an analogue connection.
Connecting a TV or a stereo TV that has component video in jacks
TV
RL YCR CB
ANALOG INPUT VIDEO INPUT
COMPONENT
AUDIO OUT VIDEO OUT
VIDEO DIGITAL RCB
CRY
COMPONENT
S-VIDEO
L
To ANALOG
AUDIOOUT jacks
To COMPONENT
VIDEO OUT jacks
To COMPONENT
VIDEO INPUT jacks
(Red)
(White)
(Red)
(White)
To ANALOG
AUDIO INPUT jacks
AUDIO cable
(supplied)
COMPONENT cable
(commercially available)
DVD Player
CAUTION:
• Do not connect the Player to a VCR. If you view the
Picture on your TV after making the connections shown
on the right, a picture noise may appear. Connect the
Player to your TV directly.
DVD
Player
VCR
TV
E57B9QD.QX3 03.5.29 4:26 PM Page 9