EasyManua.ls Logo

Sharp DW-R268A - Cautions for Use

Sharp DW-R268A
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E-4
Cautions for use
Keep at least 2 m away
Do not bend
the drain hose.
Cautions
・・・
Precautions
・・・
Precautions
Keep
20cm min.
Keep
50cm min.
Keep
20cm min.
Lighting
Musts Musts
Musts
Musts
Musts
Musts
Musts
Musts
Musts
DW-R249A_eng
Before moving the unit make sure that
the power is turned off and that the
tank is emptied.
Otherwise spilled water may wet household appliances
resulting in electric shock, short circuits or fire.
Whenever the unit is to
be left unused for a
long period, make sure
to unplug the unit for
safety.
Otherwise, electric shock
or fire may result.
Do not operate this product with the power cord still wound onto the cord clamps.
Otherwise, overheating or fire may result.
Keep the unit at least 2 m away from a TV, radio or wave clock.
Otherwise the unit may cause radio interference.
Is the unit operating at a room temperature of more than 35¡C, with the unit's WIDE SWING louver blowing toward the
rear in DRY CLOTHES mode at "Low" air flow rate or in CONTINUOUS DEHUMIDIFY mode at "Low" air flow rate?
Is the air outlet or air intake covered with a cloth or the like?
Check whether the unit is operated in a location with inadequate ventilation such as a closet or a narrow space between furniture.
Check whether the unit is operated in an improper place under direct sunshine, near heating
sources or air outlet of hot wind emerging from air conditioners or oil fan heaters.
Check that the size of the room where you are operating the unit is not too small.
When the compressor for the cooling cycle becomes abnormally hot, operation is automatically
stopped for safety. If this happens, unplug the power cord from the wall outlet, eliminate the
problem, and restart operation after a waiting period of about 40 minutes. If the [ ] indicator
still remains on, consult the shop where you purchased the unit or your nearest SHARP
Service Center.
When [ ] lights on the LED display on the operation panel and operation stops,
the unit may be used under one of the following conditions and in one of the
following locations. This is normal and does not indicate a problem with the unit.
Operating the unit in DRY CLOTHES or CONTINUOUS DEHUMIDIFY mode for long
periods causes the room temperature to rise and the air to dry out. Do not operate
the unit for long periods in rooms where people are present.
When operating the unit for a prolonged
period in the same location, check for
dirt under and around the unit.
Move the unit occasionally and clean the
floor under it.
If the unit is continuously being used for a long
period of time, make sure to inspect it regularly.
Otherwise overheating or electrical short
circuits may result.
Make sure to operate this product
only on level, stable surfaces.
An uneven surface may cause stored water to spill
and to make household furniture or appliances wet,
or to cause electric shock, short circuits or fire.
When moving the unit, drain water first from
the tank. Move its caster
by grasping the carrying
handle firmly so that the
dehumidifier may not be
inclined.
Otherwise this can cause
injuries or damage to the floor.
Leave a clearance around the unit of at
least the size shown in the drawing below.
Insufficient ventilation can result in overheating
or combustion.
If a drain hose is used, take care that the
temperature around the hose does not fall
below 0¡C.
Otherwise, water in the hose may freeze causing
undrained water to leak from the unit and make
household furniture or appliances wet.
When water is to be drained
continuously, take care that
the hose is not bent and that
the hose outlet is positioned
below the unit.
Otherwise drained water may spill
and make household appliances or
furniture wet.

Related product manuals