Sharp EC-SC95U-H - Using Method; Handheld Use

5 6
3、Press the ON/OFF to start working
4、 Clean sweeping brush
a) Clean with a cleaning brush
b）Remove the roller brush rod
As shown in the figure, turn the ON/OFF, rotate the roller brush cover, and then take out
the roller brush rod.
1、 Insert the attached accessory directly into the main body interface
Using method Using method
low gear
Middle gear
High gear
Power indicator
light
Lamp ring
Indicator lig ht of
draught fan locked-
rotor
ON/OFF
Ⅱ．Handheld use
Use a blade to cut off the
hair and other garbage
wrapped around the roller
brush rod.
Cle a n up th e cu t-of f
garbage with harrow.
Use a brush to clean up
dust and other small
particulate garbage.
Cut-off
Harrow Cleaning
a）please press the power switch, the machine goes into lower suction speed mode；
b）then press the power switch again, the machine goes into middle suction speed
mode;
c）please press the power switch once more, the machine goes into the high suction
speed mode；
d）then press the power switch once again, the machine will stop work.